Official Sharp home theater system parts

Troubleshooting your Sharp home theater system when the remote control doesn't work

• Check the batteries in the remote control. Weak or dead batteries won't power up the remote device. Replace the remote control batteries if they're weak or dead.
• The remote control has an effective range of about 20-feet. Make sure that you're within range of the home theater system when attempting to use the remote.
• Check for items blocking the RF sensor on the home theater system and move any items out of the way to allow the amplifier to receive remote control RF signals.
• The microprocessor inside the remote can fill up its internal memory or the microprocessor can get the memory scrambled at times. Reset the microprocessor and drain the memory in the remote by removing the remote control batteries and holding down one or more buttons on the remote device for several minutes. Reinstall the batteries and the remote may work normally again.
• You may need to replace the remote if it won't work after resetting the microprocessor and it has good batteries.

Common repair parts for Sharp home theater systems

• Remote control. The remote control allows you to operate the home theater system controls and make setting selections from a remote location. The remote control communicates selections to the home theater system through RF (radio frequency) signals.
• Power control board. The power control board in the home theater system amplifier provides electrical current to the component devices inside the component.
• Power cord. The power cord provides the amplifier in the home theater system with electrical current from the electrical wall outlet.
• Control panel. The control panel allows you to select sound reproduction modes and volume level. The control panel also displays settings selected on the home theater amplifier.