April 19, 2023

Whirlpool compact top-load washer error codes

These error code explanations can help you diagnose a problem with your Whirlpool compact top-load washer. The washer stops and the water level LED blinks when the washer encounters a problem. Three of the four cycle LEDs (Heavy Duty, Normal, Perm Press, Hand-Wash) turn on to indicate the specific error code. For repair how-to help, visit the PartsDirect repair help section, which includes repair help for washing machines, other major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more. Search for your model number to find a complete list of replacement parts for your washer.

Error Code

Condition

DIY advice

Normal, Quick Wash and Delicate

Long drain

Check/Repair

Check the drain hose for a clog. Check for excessive suds because the pump can't drain sudsy water. Allow time for the suds to dissipate and then resume the cycle by pressing the Start/Off button. The control will drain the washer and resume the cycle. Unplug the washer and replace the drain pump if it won't drain water when activated.

Possible parts

Drain pump

Heavy Duty, Quick Wash and Delicate

Incorrect fill water level

Check/Repair

Unplug the washer and check the wire harness connections between the water level pressure switch and the electronic control board. Reconnect any loose wires or replace the wire harness if damaged. If the wire harness connections are okay, check the air hose on the water level pressure switch for proper connection and damage. Reconnect the air hose if loose or replace it if damaged. If the wire connections and air hose are okay, replace the water level pressure switch.

Possible parts

Water level pressure switch, air hose, wire harness

Heavy Duty, Normal and Delicate

Unexpected fill during agitation or soak

Check/Repair

This code will appear if you remove garments from the basket after the washer filled. Push the Start/Off button to reset the control. The control will fill the washer and resume the selected cycle. If you didn't remove any garments, then the tub could have a leak. Unplug the washer and check the tub, drain pump and drain hose for leaks. Replace any leaking components.

Possible parts

Tub, drain pump, drain hose

Heavy Duty, Normal and Quick Wash

Slow fill

Check/Repair

Select only the Cold water temperature button when using the portable installation because you control water temperature using the sink faucets. Unplug the washer and check the water inlet valve screens for clogs. If a screen is clogged, replace the water inlet valve rather than cleaning the screen. Cleaning could allow debris to enter the valve, resulting in the valve sticking open and causing a flood. If an inlet valve won't open when activated, replace the defective water inlet valve.

Possible parts

Water inlet valve