Samsung Heat Pump Ventless Dryer DV22N error codes

The compressor thermistor senses temperature around the compressor inside the cabinet. To make sure that the compressor area is getting proper air flow, clean the lint filter and clean the heat exchanger fins. Make sure that the dryer is installed properly with proper clearance on the sides and back of the dryer. If these tips don’t help, unplug the dryer and check the resistance of the compressor thermistor. At room temperature, you should measure around 50K ohms of resistance through the thermistor. Replace the thermistor if resistance is off by more than 5K ohms.

Unplug the dryer and check the wire harness connections between the door switch and the electronic control board. If the wiring connections are okay, you’ll likely need to replace the door switch. If you replace the door switch and the problem continues, you’ll likely need to replace the electronic control board.

Press all button on the control panel and try to free up the stuck button. If the problem continues, you’ll likely need to replace the display control board.

To make sure that the compressor area is getting proper air flow, clean the lint filter and clean the heat exchanger fins. Make sure that the dryer is installed properly with proper clearance on the sides and back of the dryer. If these tips don’t help, unplug the dryer and check the resistance of the compressor thermistor. At room temperature, you should measure around 50K ohms of resistance through the thermistor. Replace the thermistor if resistance is off by more than 5K ohms. If the compressor thermistor is okay, you may need to replace the compressor.

The control detected that the drain tank overfilled 3 times in a row. Empty the drain tank. If the drain tank isn’t overfilled, unplug the dryer and test the float switch. Replace the float switch if it’s defective.

Unplug the dryer for 3 minutes and then plug it back in. If the code reappears, unplug the dryer and check the wire harness connections between all control boards in the dryer. If the wiring connections are okay, then you may need to replace the main control board.

Remove some items from the dryer to reduce the load size. If the dryer isn’t overloaded, worn drive components could be causing the 3C1 code.

Unplug the washer and check the wire harness connections between the drive motor inverter board and the drive motor. Reconnect any loose wiring connections. Check the belt and all drive components. Replace any worn drive components. If all drive components and wiring connections are okay, you may need to replace the drive motor inverter control board.

The control board detects under-voltage or overvoltage. Unplug the dryer for 3 minutes to reset the control board. If the code returns after you restore power to the dryer, check the voltage supply. If the voltage supply is normal, you may need to replace the electronic control board.

Unplug the dryer for 3 minutes to reset the control board. If the code returns after you restore power to the dryer, unplug the dryer and check the wire harness connections between the main electronic control board and the Wi-Fi control board. Reconnect any loose wiring connections. If the wiring connections are okay, you may need to replace the Wi-Fi control board or the main electronic control board.

Unplug the dryer for 3 minutes to reset the control board. If the code returns after you restore power to the dryer, unplug the dryer and check the wire harness connections between the main electronic control board and the inverter control board. Reconnect any loose wiring connections. If wiring connections are okay, you may need to replace the inverter control board or the main electronic control board.