Official Wards top-mount refrigerator parts

Finding the cause of water dripping on the floor from your Wards top-mount refrigerator

It's not unusual for a refrigerator to drip a little water on the floor after you replace the water filter—air trapped in the water dispenser system can make the water dispenser drip enough to overflow the drip tray below the dispenser. You can fix it by streaming a gallon or two of water through the dispenser to eliminate the trapped air.

If water drips on the floor from the back of the refrigerator, a leaking water inlet valve or cracked water system tubing could be the cause. A clogged or cracked defrost drain tube could also cause the leak. Defrost condensate water collects in the drain pan at the bottom of the refrigerator so a cracked or overflowing drain pan can also cause water to drip on the floor behind the refrigerator. Check the drain pan for cracks and clean out any foreign objects that may be inside the drain pan.

Excessive frost caused by a leaking door seal can also cause the defrost drain pan to overflow. Check the door gaskets and replace them if damaged.

Replacing the water inlet valve in your Wards top-mount refrigerator

• Safely store any food that could deteriorate while the refrigerator is shut off. Then unplug the refrigerator or shut off the circuit breaker for the refrigerator. Close the water supply cut-off valve for the ice maker. The valve is often on the wall behind the refrigerator, but could be attached to a water pipe under the kitchen sink or in the basement below the fridge.
• Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Place a towel under the water valve assembly to catch water. Loosen the nut on the supply water line until the water line is free.
• Use a Phillips screwdriver to remove the screws that secure the lower service panel on the back of the refrigerator. Remove the panel. Remove the screw that secures the mounting bracket to the frame of the refrigerator. Press the back of the locking tab on the wire harness to release the tab. Pull the wire harness plug off the valve. Remove the black plastic C-clip from the collar of the water line connection. Push the collar in and simultaneously pull the water line from the inlet water valve assembly.
• Push the water line into the fitting on the new water valve assembly. Reinstall the C-clip on the collar of the fitting. Push the wire harness plug back onto the spades of the water valve assembly. Push the plug in until the locking tabs snap into place. Position the bracket of the new valve assembly so that the mounting holes line up. Reinstall the mounting screw and tighten firmly. Position the lower service panel on the back of the refrigerator so that the screw holes line up. Insert the screws and tighten firmly.
• Wrap a small amount of pipe thread tape around the water supply line fitting on the back of the water valve. Fit the water line into the water valve assembly and tighten the compression nut firmly. Open the water supply cut-off valve. If the fitting leaks, tighten the compression nut and check again. Plug in the refrigerator or turn on the house circuit breaker to restore power.