$19.56 |
9% OFF Phone Price : $21.56
CONFIRM THE PART FITS
Part Information
This carburetor (part number 753-04338) is for line trimmers.
Carburetor 753-04338 mixes air and gas before the fuel mix goes to the engine.
Wear work gloves to protect your hands and work in a well-ventilated area during this repair.
Frequently Used Together
- $21.16 |22% OFF Phone Price : $27.16
- $74.45 |7% OFF Phone Price : $80.45
- $64.52 |10% OFF Was : $71.69
- $14.98 |12% OFF Phone Price : $16.98
Top models using the same part
| Model Name | Model Number | Diagram Name |
|---|---|---|
| Model #41ED790A034 Ryobi gas line trimmer | 41ED790A034 | Cylinder/fuel tank/flywheel |
| Model #790R Ryobi gas line trimmer | 790R | Cylinder/fuel tank/flywheel |
| Model #41ED775A034 Ryobi gas line trimmer | 41ED775A034 | |
| Model #TB15CS Troybilt gas line trimmer | TB15CS | Engine parts |
| Model #41ADT15C066 Troybilt gas line trimmer | 41ADT15C066 | Engine parts |
| Model #41AD765G799 MTD gas line trimmer | 41AD765G799 | Engine parts |
| Model #41AD760C799 MTD gas line trimmer | 41AD760C799 | Engine |
| Model #41AD700G799 MTD gas line trimmer | 41AD700G799 | Engine parts |
| Model #316791810 Craftsman gas line trimmer | 316791810 | Engine parts |
| Model #316791880 Craftsman gas line trimmer | 316791880 | Engine parts |
Reviews
r&r carb easy.
no problem r&r carb BIG problem with fuel line thru hole in bottom of fuel tank. also what are the 4 flat washers for? had to remove, no way would the fuel line pass through the fuel tank hole to big. had to cut off line put the filter down inside the tank then push the fuel line on to the filter, then push on the retainer ring, not easy at all,but we got it .
andy 8, ohio
Did you find this review helpful?
- Ease of Installation
- Moderate
- Duration of Installation
- 30 minutes - 1 hour
install carb. fuel lines and filter
The hardest part was installing filter and installing new gas lines
jack30, N. KY.
Did you find this review helpful?
- Ease of Installation
- Difficult
- Duration of Installation
- 30 minutes - 1 hour
Easy to Install but needed to be modified
Carb needed to be adjusted so to do that I had to use a dremil to grind cross cut into low and high jet needles to adjust. After that all was good.
Farmer2, Channahon, Il
Did you find this review helpful?
- Ease of Installation
- Moderate
- Duration of Installation
- 1 - 2 hours